The rest of the kit remains relatively standard. The Ring Alarm entry sensors are about a quarter-of-an-inch bigger than SimpliSafe's sensors and don't perform double duty like Nest's large sensors, which also sense motion. They're easy to install with the included mounting hardware and 3M-branded sticky tape, but they seem unnecessarily large and were hard to place so that the magnets would meet each other on both my front door and the back sliding door.
You can use the Video Doorbell 2 on its own and it will chime when someone presses the button or it detects motion. It will also send a push notification to your phone: tap it, and you can view the live feed from the camera immediately. But it probably makes sense to use Ring’s $49 Chime Pro accessory with it. The Chime Pro provides a speaker for the doorbell inside your house, which is much easier for everyone to hear, and it works as a network extender to make sure the Video Doorbell 2 is always connected to Wi-Fi. It’s particularly useful if your Wi-Fi router isn’t anywhere near your front door.
System is very responsive and mobile alerts are sent in real time. If the alarm goes off, you will get a mobile alert from the app with information about the actual sensor tripped; this app alert will be followed a few seconds later by a phone call from a representative checking on your well being. They will ask you for your “safe word” and if you cannot give the correct one they will dispatch a police officer. I also noticed if you cancel quickly enough with the app then they will not call you; I once cancelled after a few seconds through the app and the phone call came in, but before it could be answered it was already disconnected - which was great, no need to explain myself.
I’m confident that if Ring were a closed system—hardwired to my home network, and not at the mercy of Wi-Fi and smartphone connections—signal reliability would be a non-issue. But we’re in the wild, wild west of cloud-connected smart-home devices. The Internet of Things (ugh—that word!) is riddled with weak links, and neither Ring nor its smart-home brethren can control the infrastructure’s frequent unpredictability.
In fact, just this week I had the power go out at my home, which is also where my office is. I had deadlines to meet, so I decided to go to a coffee shop where I could work and fill up on caffeine. It wasn't until I walked into my garage that I remembered I had to manually open the garage door, disconnecting the door from the chain drive. My particular garage door opener wouldn't let me reconnect the door and the chain drive, locking it in place, so I was stuck with a garage door that anyone could lift open with ease.
1. Nest can record continiously which eliminates the problem of sleepy security cameras. As far as Ring cameras, Ring Pro offers a pre-buffer. As far as their other cameras, I’ve only tried Ring Spotlight wireless. It’s a battery-powered camera and does not pre-buffer. I believe I heard that the wired version does pre-buffer, but I haven’t personally tried it.
So far my experience with this system has been good. I am giving this product 5 stars because of the customer service experience I had when my alarm went off and the future potential I see for the whole Ring product line. However, I would like to see a couple things addressed. 1) The app needs to be easier to use, especially the cancel option, that cancel option should be there immediately and very easy to find. 2) With my old 42$ a month system I was able to control my lights, door lock and thermostat. Please please Mr. Siminoff, can we get this feature added to the system? I think adding in those features will take this from a very good low cost option to a GREAT overall option for security and home automation.
Never wonder who’s knocking at your door again. With the Ring Doorbell, you’ll receive alerts when your doorbell is pressed or motion is detected, allowing you to hear and interact with visitors. In addition to acting as a two-way communication device for your front door, it works as a security system; you can set motion detection zones from five to 30 feet outside your door. The sensor is quite sensitive, so it’s probably best to set its range and awareness levels as low as you’re comfortable with. If you’re willing to venture off Amazon (and pay a little more), the Nest Hello doorbell is another favorite option that works with Alexa.
Ring’s Alarm, which is finally shipping to customers starting today, is the latest in these new, do-it-yourself home security systems. It’s most similar to the Secure system that Nest released last year, and uses a variety of motion, entryway, and fire / carbon monoxide sensors, along with Ring’s other home security cameras to monitor your home for emergencies and intrusions.
The bottom half of the screen contains a historical list of all events (rings, motion triggers, and live view requests). Tap any event to view the associated video clip, share it, delete it, or save it. Tapping the Ring Pro button takes you to a screen where you can enable and disable ring alerts and motion alerts, view live video, and access the doorbell settings. When you tap the Live View button it launches a live stream presented in full-screen landscape mode and has buttons for two-way audio, speaker mute, and neighborhood sharing.
I can see why you’re confused because really any of these three options will do everything you want and more. Is it important to you that your security system and camera use the same app? If so, maybe eliminate abode from the list. You can use the outdoor Nest Camera with abode, but it isn’t a great experience. If you want an outdoor camera that can record continuously and not just based on motion, that would be Nest Cam. If you don’t mind if the camera only records events and as you said, want a system without “big monthly charges,” Ring is probably the best choice for you. They recently launched an indoor camera, you could then add a video doorbell (ideal) or one of their outdoor cameras to your porch. You will need five contact sensors in total. Ring Alarm will include a mobile app for you to review footage and you can expand the system down the road if needed. As it just launched and based on Ring’s history of product support, the chances that it will be outdated soon are very slim.
Ring’s sensors operate on battery power, the keypad and base station come with AC adapters, and the Z-Wave range extender plugs directly into an AC outlet. All three of those components have battery backup, so the system will continue to operate in the event of a power outage. The base station connects to your home network via hardwired ethernet or Wi-Fi. A Ring Protect subscription activates an LTE module in the base station that will keep the system connected to the internet if your broadband connection goes down. You can even run the keypad on battery power full time if you choose, since most homes don’t have AC outlets right next to doors. An LED will tell you when the battery needs to be charged.
As far as Ring Alarm, I don’t have an answer for you, but I understand and appreciate the knowledge you’ve shared. I would also agree that if they haven’t advertised jamming detection, that’s probably because it doesn’t exist. A Twitter friend of mine, who works for Underwriters Laboratories (UL), also mentioned that the system is not UL certified. Again, probably not as important to you as this jamming issue, but something interesting to note.
One of the first things I did on the Pro was to draw the precise area I wanted the camera to monitor for motion. This process is done in the mobile app, using your finger, and allows you to highlight a sidewalk but ignore the street or an area where, perhaps, you have a wind chime hanging. As you can see above, I highlighted my entire entryway, sidewalk, and driveway. The street is eliminated completely.
When you attach the Ring Video Doorbell Pro from Ring to your existing hardwired doorbell, you are able to monitor your front door area using your mobile device. The Ring Doorbell Pro features 1920 x 1080 resolution for high-quality images, and it has built-in IR LEDs for use at night or in low-light conditions. The camera has a 160° field of view for a wide coverage area, and integrated 2-way audio allows you to listen and respond to those you are monitoring
If a monitored door or window is left open when you arm the system, Ring Alarm will warn you, but give you the opportunity to push an illuminated button on the keypad to bypass that sensor. You’ll get a similar warning and opportunity when using the app to arm the system. The sensor will remain bypassed until you disarm the system again. It’s a convenient feature: If you left the upstairs window open, for example, but are in too much of a rush to run up and close it, you can take a calculated risk and secure the rest of the home.
By default, Ring Alarm offers three modes: Unarmed, Home and Armed, and Away and Armed. You can use the keypad to change modes, or use the mobile app, which also offers access to any Ring cameras you might have set up in your home. The app also provides status updates on any connected devices you have in the house, a separate history log for the alarm system and the cameras, a settings panel for configuring professional monitoring and what each mode does when activated.
The Ring Doorbell Pro comes with 30 days of Cloud recordings, however, if you would like to record footage after this, you will need to purchase a monthly or yearly Cloud subscription. With the subscription, you will be able to view and download up to 6 months of recordings, and you will also be able to share recordings with friends, neighbors, and law enforcement. Additionally, you can permanently save files that are important to you and delete any unwanted files. The package also includes mounting hardware and a power kit.
Setting the Ring to away will trigger a customizable countdown timer (from 30 seconds to 3 minutes), to give you time to cancel the alarm or exit the home. It will then push a notification to your phone when the system is armed, as well as announce audibly through the base station and keypad in the home that it has been armed. The system will also push notifications when the alarm is triggered via motion or through an entryway, as well as when it’s disarmed. In my experience, the push notifications were near instant to my device, but I would not want to rely on them in lieu of the professional monitoring, as they would not reach me if my phone had no service or was otherwise inaccessible. The only thing Ring is missing compared to a system from ADT is the ability to detect when a glass windowpane is broken, though it’s worth noting that Nest’s Secure system doesn’t offer this feature either.
It doesn't work with the Amazon Cloud Cam indoor home security camera, either. Here's what a Ring spokesperson had to say about it: "Ring Alarm does not work with Amazon Cloud Cam at this time. While I can't comment on the roadmap at this time, what I can tell you is that we will make product decisions based on what will best empower Neighbors with an affordable, effective way to monitor their homes."
Just like with Wi-Fi, the Ring platform is at the mercy of smartphone conventions it can’t control. I can’t tell you whether the video screen delays are due to poor coding in Ring’s app, performance problems with my LG G4 smartphone, or hiccups in my phone’s Wi-Fi or 4G connectivity. But the bottomline is that simply getting to the video chat screen can be a long, frustrating experience. In a perfect world, I’d be able to launch the video chat display directly from the notification shade—and do so quickly. But Ring doesn’t have actionable notifications access.
If the base station is the control center for your Ring devices, then the Amazon Echo Show is the main stage. This 10.1-inch HD screen with built-in speakers was practically made to complement your home security system. Set it up in the kitchen or living room, and you’ll be instantly connected to video and notifications from around your home. Someone at the door but you’re making dinner? Use the Amazon Echo Show to see who’s arrived. In addition to syncing with cameras and alarms, it can even listen for the sound of smoke detectors or broken glass. Talk about a smart security product.
The motion detection provided a better experience than I saw with Nest’s Cam IQ, and it would only alert me if someone was actually in front of my doorway, not down the driveway. The Ring app lets you control the motion detection’s range and set up schedules to disable the alerts. The motion alerts were useful when a delivery person would come and not bother to ring the fancy new doorbell I installed, but I ended up turning them off during the day so that I wouldn’t get a ping each time my family went in and out of the house. The scheduling system reenabled the motion alerts for nighttime so I would be alerted to an unwanted visitor at odd hours.