The square wireless base station is the main component of the Ring Alarm system. It's 6.7 x 6.7 x 1.4 inches in size, and though it lay flat on a bookshelf for this review, it can be mounted on a wall. The base station has ZigBee and Z-Wave antennas, and while the latter is available to use with compatible third-party accessories, anything that isn't Ring-certified won't work with security monitoring.
I bought this system to replace the ADT system I had for years. This system along with four Contact Sensors replaced what I had from ADT. The cost of the Ring system and year of monitoring was less than six months of monitoring from ADT. The system comes packaged nice a secure, which I am thankful for since the deliver person wasn't gentle dropping the box on my porch. I had downloaded the app and registered before the system arrived, so that part was taken care of. The included instructions and phone app walk you through the setup. It was painless and completed in about 10 minutes. I set up everything on my dining room table to go through the registration process. Once done, I installed the components where the old hardware was. Ring includes everything you need to mount (double sided tape and/or screws) all the components. Registering for monitoring was very simple too. One thing I learned that I want to pass on. do not remove the little battery tabs until the app tells you to. If you do, just open the cover, pull the battery and reinstall the tab. Just pulling the battery and reinstalling it doesn't reset the device.
If the security device isn’t try to prevent jamming at all (And the protocol is one way – from sensor to main hub), all the thief need is a 10$-30$ device (definitely not close $1,000) which actively send signals and prevent the good signal to pass (the cheap signal jammer can be adjusted to frequency like you turn on a radio. the frequency itself is probably common in all devices or can be found on device manual) [not putting a security sign is https://en.wikipedia.org/wiki/Security_through_obscurity but it may be better than nothing].
Second, Ring sells a contact sensor. The two-piece sensor can be placed on doors or windows and will notify you of open/close movements. Third, they sell a pet-friendly motion detector. Fourth, they sell a range extender. The range extender is the only sensor that requires AC power, but it also includes 24-hour battery backup. The Range Extender is used to boost the signal emitted by your Base Station to help eliminate dead zones.
To start I shut off the breaker that powers my existing doorbell before removing it and detaching the two wires. I slid off the Ring Pro's detachable faceplate and attached the two wires to the terminals. I then attached the doorbell to the outside of my house using the included mounting screws. I already had a Ring account from previous reviews but if you haven't created one, now's the time to download the app and do so.
If the security device isn’t try to prevent jamming at all (And the protocol is one way – from sensor to main hub), all the thief need is a 10$-30$ device (definitely not close $1,000) which actively send signals and prevent the good signal to pass (the cheap signal jammer can be adjusted to frequency like you turn on a radio. the frequency itself is probably common in all devices or can be found on device manual) [not putting a security sign is https://en.wikipedia.org/wiki/Security_through_obscurity but it may be better than nothing].
I’m not certain about Nest, but I asked abode about this before. They said, “We have what is called abode Signal Guard. Unlike other smash and grab solutions, the Signal Guard works whether your system is self-monitored or professionally monitored. The abode Signal Guard alarm acts just like a normal alarm where notifications are sent and the siren(s) go off until the alarm is disabled. If you are a professionally monitored customer, the monitoring center is notified of the abode Signal Guard event.”
So far my experience with this system has been good. I am giving this product 5 stars because of the customer service experience I had when my alarm went off and the future potential I see for the whole Ring product line. However, I would like to see a couple things addressed. 1) The app needs to be easier to use, especially the cancel option, that cancel option should be there immediately and very easy to find. 2) With my old 42$ a month system I was able to control my lights, door lock and thermostat. Please please Mr. Siminoff, can we get this feature added to the system? I think adding in those features will take this from a very good low cost option to a GREAT overall option for security and home automation.
If you do have smart lights and want to control them with a contact sensor or motion detector, you will need to install separate ones in addition to Ring’s, which can make your front door look like it’s grown barnacles with all of the sensors installed. Another simple integration would be to set a smart thermostat to its away mode when the Alarm is set to away, and then switch it back to its home mode when the Alarm is disarmed, but that’s currently not possible either.
Consumer Reports is an independent, non-profit organization dedicated to helping consumers. We make it easy to buy the right product from a variety of retailers. Clicking a retailer link will take you to that retailer’s website to shop. When you shop through retailer links on our site, we may earn an affiliate commission – 100% of the fees we collect are used to support our mission. Learn more. Our service is unbiased: retailers can’t influence placement. All prices are subject to change.

I agree! This was a great comparison article for me and timely. A neighbor of ours just recently got robbed and led us to upgrade our basic home security features. I am curious if this article will be updated once Abode Iota is launched. I like the al a carte of monitoring with Abode and may end up getting nest outdoor camera with Abode. Thank you again!

Be prepared with a Ready America Cold Weather Be prepared with a Ready America Cold Weather Survival Kit. Our two-person kit contains essential lifesaving items including food and water survival blankets body warmers and hand warmers a snow shovel to dig your vehicle out of tight spots a flashlight/radio/cell phone charger and more. When winter comes cold weather ...  More + Product Details Close
The most useful product offered by Nest that the Ring system does not have is a connected lock. This tamper‑proof, key‑free deadbolt connects to the Nest app, letting you lock and unlock your door remotely. Users can also create passcodes for family, guests and people they trust, or give them a Nest Tag programmed to let them in only at certain times of the day.
Ring Neighborhoods is a service that lets you share videos with other nearby Ring users or anyone who has downloaded the Ring app. The service ties into another feature called Ring Locations. Ring Locations allows you to attribute your different Ring devices to different locations and customize user access for the same. For example, you might have your Ring Doorbell at one location where your kids have Homeowner user status, while you have Ring Alarm at another location and limit their access to Neighbor.
The picture isn’t quite as rosy if you’re also looking for a full-fledged smart home system. Ring Alarm is positively capable of being a great smart home controller. But it’s not that today. And to be fair, Ring isn’t promising that it ever will be—at least not officially. But they wouldn’t have built in Z-Wave, ZigBee, and whatever that third mystery radio is if they didn’t intend to go down that path.
You have 2 alarm modes: home and away. Using the app you get to chose which sensors will trip home mode and away mode; to be a little more specific, in the app you can select a sensor and check a box next to away and a box next to home if you want it to trip the alarm even if your alarm is active in “home mode” such as when you’re sleeping at night, where motion sensors inside won’t trip the alarm, but doors or windows opening will do so. You can also select a motion sensor and select a lower sensitivity level in case you have pets. You can do all this from the app even away from home.
Though the Ring Alarm system covers the bases for a home security setup, there’s a lot of room for integration with other smart home products that Ring has left on the table. For example, it’s not possible to use the Ring’s motion or contact sensors to trigger lights or adjust a smart thermostat when you leave or come back home. This is despite the fact that the Ring Alarm sensors are based on Z-Wave technology, which is a widely used smart home standard.
“We had this pretty much set out, but because we got sued by ADT, because we’re doing something so competitive to them that they had to try to step in our way, which I think is a complement, it released a lot of information about this. I believe that’s why you saw a half-baked announcement that came from a competitor that didn’t even have full pricing and shipping dates on everything. I think it was kind of the opposite; it’s amazing that a competitor that size is reacting to us, and I’ll take that as a complement, too.”

“Where we’re going with it is once we know this, we can then do things in our network which include, you know if someone’s walking around your house at 3 AM in the morning and your house is on stay mode, then we can do a different type of alert or sort of raise the alert level on that camera,” explained Siminoff. “And then we do things like deliver presence saying ‘How can I help you, what are you doing?’ and so really taking that presence and that interactivity, and that pre-crime thing that Ring is so good at and take it to the next level by knowing the status.”
Aside from the obvious value proposition, Ring’s big pitch for the Alarm system is its simplicity. Though it has all of the features necessary for a proper home security system – professional monitoring, battery and cellular backup for the event of a power loss – installing the Ring Alarm in my home took less than 20 minutes and involved following the app’s instructions to get the base station on my Wi-Fi network and register each included piece. Cleverly, Ring presets the included motion detector, contact sensor, and range extender to pair with the hub that’s in the box, so getting them set up is just a matter of pulling the battery tab to wake them up and waiting a moment for the app to find them.
You’ll need to connect the Pro to a doorbell transformer that supplies 16- to 24 volts of AC power. If your home already has a wired doorbell, it’s probably at this voltage, but you’ll need to check. And not every home has doorbell wiring. If yours doesn’t then you’ll need to install power at your porch (or get an electrician to do it) if you want to use this.
abode uses the abode app. If an event occurs, you will receive a notification on your phone. From the app, you can decide how to respond to events. You can review video footage, notify the police, the monitoring center, or even your family. You can also view sensor history and manage your rules. For example, you can create a “coming home” rule that turns on the lights and unlocks the door. And of course, you can use the app to arm and disarm the system.
Update 1/24/16 - I have found a fantastic use for the Ring Doorbell and Chime. My mother-in-law, now in her 90s, lives by herself. She has become hard-of-hearing and often does not hear the doorbell. By installing the Ring on her door, she now is bothered much less (solicitors tend to recognize it and don't seem to like it) and when someone rings the bell, the Chime, placed by her favorite chair, gives her a better chance of hearing someone at the door.
×